baropf.blogg.se - Fritzing 40 pin raspberry pi header

Do not mix use old batteries with new ones, avoid using batteries of different brands.

Do not use inferior charger/charging panel to recharge the battery. Do not reversely connect the polarities when recharging or discharging the battery.They may cause fire, personal injury, or property damage, if they're not properly recharged or used. Li-ion and Li-po batteries are quite unstable.Note 3: Please use the charger provided, the module may be destroyed by other unsuitable power adapters/chargers. Note 2: The board may not work when you install the batteries for the first time, you need to charge the batteries for a while to activate them. Don't charge batteries if you reverse them. Note 1: Please check the WARNING LED when you install batteries, make sure that you set all the batteries in the correct way. WARNING LED are the indicators of batteries, they turn on if you reverse batteries. The switch is the power switch, you can turn it into ON/OFF to turn on/off Jetson Nano Developer Kit. You can plug the 8.4V/2A charger provided for charging the batteries. Note that the 8.4V interface is the charging port. Battery supported：18650 Li battery (NOT included).Batteries warning indicators, easy to check if the battery is connected correctly.

5V USB output, convenient for powering other boards.

Onboard 5V regulator, up to 2.5A continuous output current.

Multi battery protection circuits: overcharge/discharge protection, over current protection, short circuit protection, and reverse protection, along with the equalizing charge feature, more safe and stable.

I2C bus communication, monitoring the batteries voltage, current, power, and remaining capacity in real-time.

Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards.

UPS HAT For Raspberry Pi, 5V Uninterruptible Power Supply, Multi Battery Protection Circuits.